Is a Reversing Light an MOT Failure? The Answer Since 2018
It is one of the most googled MOT questions there is, usually typed in the car park immediately after someone spots a dead bulb the night before the test. Here is the straight answer, and the wording you would see on the certificate:
Reversing lamp inoperative (4.6.1 (a))
The Short Answer
Yes, on most cars on the road today. Reversing lamps are inspected on vehicles first used from 1 September 2009, and one that does not work is a Major defect: the car fails. That applies to every reversing lamp fitted, not just one. On vehicles first used before September 2009, reversing lamps are not inspected at all.
The rule exists because a working reversing lamp is both your rear visibility when backing up at night and the signal that tells pedestrians and other drivers you are about to move. It is one of the cheapest faults on the whole car to fix, so there is no good reason to fail a test on it.
What Usually Causes a Dead Reversing Light
- The bulb itself: the overwhelming favourite, and often a two-minute fix.
- A corroded bulb holder or earth contact in the rear light cluster.
- The reversing light switch, usually screwed into the gearbox and operated by the linkage when you select reverse.
- A blown fuse or a damaged wire, especially on cars with towbar wiring spliced in.
If a new bulb does not wake it up, the switch and wiring are the next suspects: that is a quick diagnostic job rather than a guessing game.
Worth Knowing Before Test Day
The MOT’s lighting section is the single biggest source of failures nationally, and almost all of it is bulbs: stop lamps, position lamps, number plate lamps and indicators are all tested, and like the reversing lamp, most of those fail the car when they do not work. A one-minute walk around the car with the lights on, and a helper pressing the brake pedal, catches the lot before the tester does. Our guide to what’s checked in an MOT runs through the full list, and the most common MOT failures shows just how dominant simple lighting faults are.
Bulbs Fitted While You Wait
Any of our 12 branches across Nottinghamshire will check and replace exterior bulbs while you wait, reversing lamps included, and if the fault turns out to be the switch or wiring we will diagnose it properly and confirm the price before any work starts. Due a test anyway? Book an MOT online, or set up a free MOT reminder so the date never creeps up on you again.
Frequently asked questions
Will my car fail its MOT if the reversing light doesn’t work?
Yes, on vehicles first used from 1 September 2009: an inoperative reversing lamp is a Major defect, so the car fails. On older vehicles reversing lamps are not inspected at all.
Do both reversing lights need to work for the MOT?
Many cars only have one reversing lamp by design, and that is completely fine: at least one must be fitted. But every reversing lamp that is fitted is inspected, so if your car has two, both need to work.
Are front fog lights an MOT failure?
Only on cars first used on or after 1 March 2018: on those, a wired-up front fog lamp that does not work is a Major defect, the same as a dead rear fog lamp. On older cars the front fogs are not inspected, and fogs that were never connected are not required to work.
Why is my reversing light not working after I changed the bulb?
The usual suspects are a corroded holder or earth in the light cluster, the reversing switch on the gearbox, or a fuse or wiring fault. All are quick to diagnose properly with the right equipment.
How much does it cost to fix a reversing light fault?
It depends on the underlying cause and the vehicle, which is why we always inspect first. Once we can see exactly what is needed we will explain it in plain English and confirm the price with you before any work starts.







